球探网比分

Contact

Anhui Secco Intelligent Technology Co., Ltd.

Sales address: Qianshan North Road, Shushan District, Hefei

5th Floor, Block B, North Building 499

Phone in charge: 187-0551-4743 Mr. Zhang

Telecom fixed line: 0551-65153937

0551-65153708

Business QQ: 390120255

Product URL: junpairhy.com

Search
Your location : Home > News > Corporate Announcement

Points for Attention to Installation and Acceptance of Automatic Sensor Doors

2015-4-29 09:00:28 Article source: http://junpairhy.com/click :
1. The appearance should be beautiful:
The surface paint film of electric doors and windows should be smooth and bright, without quality defects such as drips, bubbles, wrinkles, and no corrosion points and residues;

2. The hinge must be accurately positioned and firmly installed:
If the hinges are not upright, it will cause the electric doors and windows not to match with the sleeve, and the electric door and window switches will not be smooth. You can unscrew each hinge first, and then adjust the degree of fit of the auto-sensing door and window leaf, and then tighten all the screws after adjusting and repairing. If the hinge screw is short, or when you screw it in when you screw it on, if you do not tighten the screw, or if the screw is skewed, it will cause the electric door and window leaf to hit.

3. The electric doors and windows must be square and can not be warped and deformed. The electric doors and windows can just be stuffed into the electric doors and windows and coincide with the electric doors and windows:
If the electric doors and windows have a large gap, it is mainly because the planing and repairing is not allowed during installation or the electric doors and windows are not perpendicular to the ground. The electric doors and windows can be removed and re-planed; if the electric doors and windows are not vertical, the inner gasket should be straightened. .

4. There should be grassroots materials in the electric door and window covers:
When the window cover is made with fine workmanship or density, the base layer should be fixed to the window base keel before nailing the line; the door cover should be made of material into a frame, planed and straightened, and then assembled and installed on the wall, and then Covers the base and finishes. Tap the side of the electric door and window cover with your hands. If a hollow drum sounds, it means that the bottom layer has no basic work such as padding and should be removed and redone.

5. The door lock should be opened and locked smoothly, and the two parts locked on the door leaf should match:
Improper locking will cause the door leaf switch to be uncomfortable. Remove the lock tongue, repair the tongue groove with a chisel, adjust the position of the door lock tongue, and then install it. In addition, the opening direction of the door must also meet the requirements. This article comes from: junpairhy.com